Table of Contents
Advertisement
Configuration Tasks for RA to MPLS VPN
Example 3-9
Example 3-9
Router(config)# ip vrf vpn1
Router(config-vrf)# vpn id al:3f6c
Router(config-vrf)# end
Configuring and Associating Virtual Private Networks
To add a virtual private network (VPN) service to your MPLS configuration, you perform the following
tasks:
•
•
Configuring Virtual Private Networks
To configure dial-in and dial-out virtual private networks (VPNs), perform the following tasks:
•
•
For more information about configuring virtual private networks, see the "Configuring Virtual Private
Networks" chapter in the Cisco IOS Dial Technologies Configuration Guide, Release 12.2. This chapter
describes the procedures used to configure, verify, monitor, and troubleshoot VPNs and also provides
configuration examples.
Associating VPNs with a Virtual Template Interface
After you configure the VPNs, associate each one with a virtual template interface. To do this
association, perform the following tasks:
•
•
Note
Creating a VRF Configuration for a VPN
To create a VRF configuration for a VPN, enter the following commands beginning in global
configuration mode:
Command
Step 1
Router(config)# ip vrf vrf-name
Step 2
Router(config-vrf)# rd route-distinguisher
Cisco 10000 Series Router Software Configuration Guide
3-28
assigns a VPN ID to the VRF named vpn1.
Configuring a VPN ID
Configure VPNs
Associate VPNs with a virtual template interface
Enable a VPN tunnel
Configure VPN tunnel authentication
Creating a VRF Configuration for a VPN, page 3-28
Associating a VRF Configuration for a VPN with a Virtual Template Interface, page 3-29
Do not enable VPN service on the fa0/0/0 management interface. The configuration for this
interface is included in the configuration file.
Chapter 3
Purpose
Enters VRF configuration mode and defines the VPN routing
instance by assigning a VRF name.
Creates routing and forwarding tables.
Configuring Remote Access to MPLS VPN
OL-2226-23
Advertisement
Table of Contents
Troubleshooting
