Configuring Mr-Aps On Channelized Line Cards - Cisco 10000-2P2-2DC Software Configuration Manual

Multirouter Automatic Protection Switching
Command
Step 9
Router(config-if)# aps protect circuit-number
ip-address
Step 10
Router(config-if)# exit

Configuring MR-APS on Channelized Line Cards

To configure MR-APS on channelized line cards, enter the following commands beginning in global
configuration mode.
Command
Step 1
Router(config)# redundancy
Step 2
Router(config-r)# associate slot slot-one
mr-aps
Step 3
Router(config-r)# exit
Step 4
Router(config)# controller SONET
slot#/subslot#/port#
Step 5
Router(config-controller)# aps group
group-number
Step 6
Router(config-controller)# aps working
circuit-number
Step 7
Router(config-controller)# exit
Step 8
Repeat steps 1 through 5 on the second router to configure the protect interface. Substitute the appropriate slot
numbers, interface types, and interface numbers. After you complete step 5, go to step 9.
Step 9
Router(config-controller)# aps protect
circuit-number ip-address
Step 10
Router(config-controller)# exit
Cisco 10000 Series Router Software Configuration Guide
14-22
Chapter 14 Configuring Automatic Protection Switching
Purpose
Configures an interface as a protect interface.
The ip-address argument specifies the IP address of the
router that has the working interface.
Exits interface configuration mode and returns to global
configuration mode.
Purpose
Enters redundancy configuration mode, which allows you
to associate two line cards as a redundant pair.
Logically associates slots for APS processor redundancy.
To allow MR-APS to operate, you must associate a slot on
the working interface of one router and with a
corresponding protect interface on a second router.
Exits redundancy configuration mode and returns to global
configuration mode.
Specifies the interface type and number. Enters controller
configuration mode.
Permits more than one APS protect and working interface
to be supported on a router.
Configures an interface as a working interface.
Exits controller configuration mode and returns to global
configuration mode.
Configures an interface as a protect interface.
The ip-address argument specifies the IP address of the
router that has the working interface.
Exits controller configuration mode and returns to global
configuration mode.
OL-2226-23