Configuration Tasks For L2Vpn; Setting Up The Pseudowire-Atom Circuit - Cisco 10000-2P2-2DC Software Configuration Manual

Configuration Tasks for L2VPN

Configuration Tasks for L2VPN
To configure L2VPN, you have to configure the following L2VPN features:
•
•
•
•
•
•
•
•
•
•
•
•
•
Setting Up the Pseudowire—AToM Circuit
The successful transmission of the Layer 2 frames between PE routers is due to the configuration of a
connection called a pseudowire between the routers. You specify the following information on each
PE router:
•
•
•
Cisco 10000 Series Router Software Configuration Guide
20-12
Setting Up the Pseudowire—AToM Circuit, page 20-12
Configuring ATM AAL5 SDU Support over MPLS, page 20-14
Configuring ATM-to-ATM PVC Local Switching, page 20-14
Configuring OAM Cell Emulation for ATM AAL5 SDU Support over MPLS, page 20-15
Configuring Ethernet over MPLS, page 20-19
IEEE 802.1Q Tunneling for AToM—QinQ, page 20-22
Remote Ethernet Port Shutdown, page 20-25
Configuring Frame Relay over MPLS, page 20-28
Configuring Frame Relay-to-Frame Relay Local Switching, page 20-31
Configuring HDLC and PPP over MPLS, page 20-36
Estimating the Size of Packets Traveling Through the Core Network, page 20-37
Setting Experimental Bits with AToM, page 20-38
Configuring QoS Features, page 20-40
The type of Layer 2 data to be transported across the pseudowire, such as Ethernet, Frame Relay, or
ATM
The IP address of the loopback interface of the peer PE router, which enables the PE routers to
communicate
A unique combination of peer PE IP address and VC ID that identifies the pseudowire
Chapter 20 Configuring L2 Virtual Private Networks
OL-2226-23