Table of Contents
Advertisement
Half-Duplex VRF
Configuration Tasks for Half-Duplex VRF
To configure the Half-Duplex VRF feature, perform the following configuration tasks:
•
•
•
Configuring Upstream and Downstream VRFs on the L2TP Access Concentrator and PE Router
To configure the upstream and downstream VRFs on the PE router, enter the following commands
beginning in global configuration mode:
Command
Step 1
Router(config)# ip vrf vrf-name
Step 2
Router(config-vrf)# rd route-distinguisher
Step 3
Router(config-vrf)# route-target {import |
export | both} route-target-ext-community
Example 4-7
Example 4-7
Router(config)# ip vrf D
Router(config-vrf)# description Downstream VRF - to subscribers
Router(config-vrf)# rd 1:8
Router(config-vrf)# route-target export 1:100
Example 4-8
Example 4-8
Router(config)# ip vrf U
Router(config-vrf)# description Upstream VRF - to hub PE
Router(config-vrf)# rd 1:0
Router(config-vrf)# route-target import 1:0
Cisco 10000 Series Router Software Configuration Guide
4-24
Configuring Upstream and Downstream VRFs on the L2TP Access Concentrator and PE Router,
page 4-24
Associating VRFs, page 4-25
Configuring RADIUS, page 4-26
shows how to configure a downstream VRF named D.
Configuring the Downstream VRF
shows how to configure an upstream VRF named U.
Configuring the Upstream VRF
Chapter 4
Purpose
Enters VRF configuration mode and defines the VRF instance by
assigning a VRF name.
Creates routing and forwarding tables.
Creates a list of import and export route target communities for
the specified VRF.
The import keyword is required to create an upstream VRF. The
upstream VRF is used to import the default route from the hub
PE router.
The export keyword is required to create a downstream VRF.
The downstream VRF is used to export the routes of all
subscribers of a given service that the VRF serves.
Configuring Multiprotocol Label Switching
OL-2226-23
Advertisement
Table of Contents
Troubleshooting
