L2Tp Network Server - Cisco 10000-2P2-2DC Software Configuration Manual

10000 series
Table of Contents

Advertisement

L2TP Network Server

Command
Router# show vpdn session
Router# show vpdn tunnel
L2TP Network Server
The Cisco 10000 series router can function as an L2TP network server (LNS). By using the managed
LNS features introduced in Cisco IOS Release 12.2(4)BZ1, the Cisco 10000 series router terminates
L2TP sessions from the LAC and places each session into the appropriate VRF instance based on the
L2TP tunnel the session arrived in. The Cisco 10000 router then routes each session within the VRF to
the destination network.
The LNS is a peer to the LAC and sits on one side of an L2TP tunnel. The LNS routes packets to and
from the LAC and a destination network. Acting as the LNS, you can configure the Cisco 10000 series
router to terminate the PPP sessions and route the client IP packets onto the ISP or corporate network
toward their final destination (see
sessions in VRFs before routing the packets, as shown in
Figure 5-3
CPE
All of a service provider's subscribers do not share the same L2TP trunk interface. Typically, the
Cisco 10000 router uses virtual local area networks (VLANs) to separate a service provider's subscriber
traffic. The Cisco 10000 series router can also use permanent virtual circuits (PVCs) or a separate
physical interface for each provider to separate traffic. A virtual template interface configures the user
sessions in a tunnel and applies to all users in the same VRF.
The LNS feature is described in the following topics:
Cisco 10000 Series Router Software Configuration Guide
5-22
Chapter 5
Managed LNS Topology
Access network
(ATM or Ethernet)
Virtual Template Interface, page 5-23
Virtual Routing and Forwarding Instance, page 5-23
Per VRF AAA, page 5-23
Private Servers, page 5-24
RADIUS Attribute Screening, page 5-24
Packet Fragmentation, page 5-24
Configuring the Layer 2 Tunnel Protocol Access Concentrator and Network Server
Purpose
Verifies active L2TP sessions in a VPDN environment.
Verifies active L2TP tunnel information in a VPDN environment.
Figure 1-1 on page
1-3). You can also configure the LNS to place the
Figure
LAC
IP
transport
network
PPP in L2TP
sessions
5-3.
Wholesale LNS
Retail LNS
provider
provider
Cisco 10000 ESR
VRF 1
VRF 2
VRF n
L2TP sessions
are terminated
and placed in a VRF
Provider 1
Provider 2
Provider n
OL-2226-23

Advertisement

Table of Contents
loading

This manual is also suitable for:

1000510008

Table of Contents