Monitoring And Maintaining The Sr-Aps Configuration - Cisco 10000-2P2-2DC Software Configuration Manual

Single-router Automatic Protection Switching
Table 14-1 Configuration File—Redundancy Enabled and Disabled
Redundancy Enabled
card 5/0 1oc12pos-1
card 6/0 1oc12pos-1
!
redundancy
associate slot 5 6
!
interface POS5/0/0
ip address 5.5.5.5 255.255.255.0
no ip directed-broadcast
ip mtu 1500
loopback internal
no keepalive
aps mode linear 1+1 nonreverting
unidirectional
aps signal-fail BER threshold 3
aps signal-degrade BER threshold 5
crc 32
clock source internal
pos scramble-atm
pos threshold sd-ber 5
pos flag c2 0
pos flag j0 0

Monitoring and Maintaining the SR-APS Configuration

To monitor and maintain the configuration of SR-APS, enter any of the following commands in
privileged EXEC mode:
Command
Router# show aps
Router# aps clear [POS | SONET]
slot#/subslot#/port#
Router# aps force [POS | SONET]
slot#/subslot#/port# from [working | protection]
Cisco 10000 Series Router Software Configuration Guide
14-30
Redundancy Disabled
card 5/0 1oc12pos-1
card 6/0 1oc12pos-1
!
interface POS5/0/0
ip address 5.5.5.5 255.255.255.0
no ip directed-broadcast
ip mtu 1500
loopback internal
no keepalive
crc 32
clock source internal
pos scramble-atm
pos threshold sd-ber 5
pos flag c2 0
pos flag j0 0
!
interface POS6/0/0
ip address 6.6.6.6 255.255.255.0
no ip directed-broadcast
ip mtu 1500
no ip route-cache cef
no keepalive
...
Purpose
Displays the status of the APS-configured slot.
Clears the SR-APS commands on a channel and enables
automatic SR-APS switching.
Forces a switch from the working channel to the protection
channel, or from the protection channel to the working channel.
from working—Forces a switch from the working channel to the
protection channel.
Note This command has no effect if the protection channel is
currently the active channel.
from protection—Forces a switch from the protection channel to
the working channel.
This command has no effect if the working channel is
Note
currently the active channel.
Chapter 14 Configuring Automatic Protection Switching
OL-2226-23