Limitations For Ipv6 - Cisco 10000-2P2-2DC Software Configuration Manual

Chapter 24 Configuring IP Version 6
•
•
•

Limitations for IPv6

Not all types of IPv6 Tunneling are supported on the Cisco 10000 routers with this release. Among those
not supported are the following:
•
•
•
•
•
•
•
The following security ACL features are not supported for IPv6:
•
•
OL-2226-23
RPF strict check mode verifies that the source IP address exists in the FIB table and verifies that the
source IP address is reachable through the input port
Security ACLs
For IPv6, ACEs include the following new fields:
Flow Label
–
Presence of Routing Header
–
"Undetermined Transport"
–
QoS
QoS matching is performed only on the following subset of fields, which are common to IPv4 and
IPv6:
dscp/precedence
–
access group (matches only on ACE entries common to IPv4 and IPv6)
–
class
–
qos group
–
mpls
–
input if
–
l2 cos
–
discard class
–
The match protocol command now includes the ipv6 keyword to specify this protocol as a matching
criterion. The match ip dscp and match ip precedence commands apply only to IPv4 traffic. The
match dscp and match precedence commands apply to both IPv4 and IPv6 traffic.
For marking packets, the set ip dscp and set ip precedence commands have been changed to set
dscp and set precedence. They now apply to both IPv4 and IPv6 traffic.
ICMP handling and generation are performed on the route processor and are not handled in PXF
Automatic 6to4
ISATAP
Automatic IPv4-compatible
IPv6 over L2TPv3
6over4 (RFC 2529)
IPv6 in IPv6 GRE
IPv6 over UTI
Incremental compilation (The Cisco 10000 routers use pre-compiled ACLs.)
Single-step classification
Cisco 10000 Series Router Software Configuration Guide
Limitations for IPv6
24-3