Configuring The Lns For Radius Tunnel Accounting - Cisco 10000-2P2-2DC Software Configuration Manual

Chapter 5 Configuring the Layer 2 Tunnel Protocol Access Concentrator and Network Server

Configuring the LNS for RADIUS Tunnel Accounting

To configure the LNS for RADIUS tunnel accounting, perform the following required configuration
tasks:
•
•
Configuring AAA Accounting Using Named Method Lists
To configure AAA accounting using named method lists, enter the following commands beginning in
global configuration mode:
Command
Step 1
Router(config)# aaa accounting {system |
network | exec | connection | commands
level} {default | list-name} {start-stop
| stop-only | none} [method1
[method2...]]
Step 2
Router(config)# line [aux | console | tty
| vty] line-number [ending-line-number]
or
Router(config)# interface interface-type
interface-number
Step 3
Router(config-line)# accounting {arap |
commands level | connection | exec}
{default | list-name}
or
Router(config-if)# ppp accounting
{default | list-name}
Note System accounting does not use named method lists. For system accounting you can define only the
default method list. For more information, see the "Configuring Accounting" chapter in the Cisco IOS
Security Configuration Guide, Release 12.2.
Configuring RADIUS for Tunnel Accounting
Cisco IOS Release 12.2(15)BX enhances the AAA accounting feature by adding the ability to include
tunnel-related statistics in the RADIUS information. To collect tunnel usage information, you must
configure the following attributes on the RADIUS server:
•
•
OL-2226-23
Configuring AAA Accounting Using Named Method Lists, page 5-39
Configuring RADIUS for Tunnel Accounting, page 5-39
Acct-Tunnel-Connection—Specifies the identifier assigned to the tunnel session. This attribute and
the Tunnel-Client-Endpoint and Tunnel-Server-Endpoint attributes provide a way to uniquely
identify a tunnel session for auditing purposes.
Acct-Tunnel-Packets-Lost—Specifies the number of packets lost on a given link.
Purpose
Creates an accounting method list and enables accounting.
The list-name argument is a character string used to name the list
you are creating.
Enters the line configuration mode for the line to which you want
to apply the accounting method list.
Enters the interface configuration mode for the interface to which
you want to apply the accounting method list.
Applies the accounting method list to a line or a set of lines.
Applies the accounting method list to an interface.
Cisco 10000 Series Router Software Configuration Guide
L2TP Network Server
5-39