Verification Example For The Show Ppp Multilink Command - Cisco 10000-2P2-2DC Software Configuration Manual

Chapter 22 Configuring Multilink Point-to-Point Protocol Connections
Keepalive not set
DTR is pulsed for 2 seconds on reset
LCP Open, multilink Open
Open:IPCP
Last input 15:24:43, output never, output hang never
Last clearing of "show interface" counters 15:27:59
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
36 packets input, 665 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
31 packets output, 774 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions

Verification Example for the show ppp multilink Command

Example 22-13
information about the MLP over ATM bundle (Multilink3) displays first. Information about the member
links then displays, including the number of active and inactive member links. Class fields are omitted
from the output; everything is implicitly in receive class 0 and transmit class 0.
Example 22-13 Sample Output for the show ppp multilink Command
Router# show ppp multilink
Multilink3, bundle name is multilink_name-3
Endpoint discriminator is multilink_name-3
Bundle up for 3d21h, total bandwidth 128, load 1/255
Receive buffer limit 24384 bytes, frag timeout 1000 ms
Bundle is Distributed
C10K Multilink PPP info
Member links: 2 active, 0 inactive (max 10, min not set)
The following list describes the bundle-level fields and lines in the show ppp multilink command
output:
•
•
•
•
OL-2226-23
shows sample output from the show ppp multilink command. In the example,
0/0 fragments/bytes in reassembly list
1 lost fragments, 1 reordered
0/0 discarded fragments/bytes, 0 lost received
0x831D received sequence, 0x0 sent sequence
Bundle transmit info
send_seq_num 0x0
Bundle reassembly info
expected_seq_num:
Vi5, since 3d21h, 16 weight, 82 frag size
Vi4, since 3d19h, 16 weight, 82 frag size No inactive multilink interfaces
Bundle name is name—The bundle identifier for the bundle.
Bundle up for time—The elapsed time since the bundle first came up.
load n/255—The traffic load on the bundle as multilink computes loads for bandwidth-on-demand
purposes. This load might count all traffic, or just inbound or outbound traffic, depending on the
configuration.
Receive buffer limit n bytes—The maximum amount of fragment data that multilink can buffer in
its fragment reassembly engine for each receive class. This amount is derived from the configured
slippage constraints.
0x00831E
Cisco 10000 Series Router Software Configuration Guide
Verifying and Monitoring MLP Connections
22-45