Configuration Tasks And Examples; Local Switching - Cisco 10000-2P2-2DC Software Configuration Manual

ATM to Frame Relay—Routed Interworking
Figure 21-17
Bridged frames or
IP packets or Other
ATM CE

Configuration Tasks and Examples

This section describes configuration tasks for and examples of two L2VPN technology solutions
•
•

Local Switching

Figure 21-8
DLCI feature and provides examples.
ATM AAL5 to FR DLCI
To configure the ATM AAL5 to FR DLCI feature on a router, use the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
The following example shows how to configure the ATM AAL5 to FR DLCI feature on a router:
config t
interface atm 2/0/0
pvc 0/200 l2transport
encapsulation aal5snap
frame-relay switching
interface serial 2/0/0:1
encapsulation frame-relay
Cisco 10000 Series Router Software Configuration Guide
21-28
ATM to Frame Relay Routed Interworking
payload types
ATM Link
PE
Local Switching
AToM
shows LS configurations. This section explains LS configuration of the ATM AAL5 to FR
config t
interface atm slot/subslot/port
pvc vpi/vci l2transport
encapsulation aal5snap
interface serial slot/subslot/port[:channel | .channel]
encapsulation frame-relay
frame-relay interface-dlci DLCI switched
connect connection-name atm slot/subslot/port vpi/vci serial slot/subslot/port[:channel |
.channel] interworking ip
MPoMPLS
Tunnel LSP
P Router P Router
P Router
MPLS Network
ATM to FR Interworking
Chapter 21 Configuring L2VPN Interworking
Bridged frames or
IP packets or Other
payload types
FR Link
PE
FR CE
OL-2226-23