Cisco 10000-2P2-2DC Software Configuration Manual page 252

ATM PVC Autoprovisioning
Command
Step 3
Router(config-if-atm-range)# create
on-demand
Step 4
Router(config-if-atm-range)# idle-timeout
[time-out-in-seconds]
[minimum-traffic-in-kbps]
Example 8-6
for 300 seconds.
Example 8-6
Router(config)# int atm 3/0/0.1 multipoint
Router(config-subif)# atm pppatm passive
Router(config-subif)# range pvc 100/100 100/200
Router(config-subif-atm-range)# create on-demand
Router(config-subif-atm-range)# idle-timeout 300
Enabling ATM PVC Autoprovisioning on a Specific PVC Within a PVC Range
To enable ATM PVC autoprovisioning on a specific PVC within a PVC range, enter the following
commands beginning in global configuration mode.
Command
Step 1
Router(config)# interface atm slot/0
[.subinterface-number {multipoint |
point-to-point}]
Step 2
Router(config-if)# range [range-name] pvc
start-vpi/start-vci end-vpi/end-vci
Step 3
Router(config-if-atm-range)# pvc-in-range
[pvc-name] [vpi/vci]
Step 4
Router(config-if-atm-range-pvc)# create
on-demand
Step 5
Router(config-if-atm-range-pvc)#
idle-timeout [time-out-in-seconds]
[minimum-traffic-in-kbps]
Cisco 10000 Series Router Software Configuration Guide
8-10
Purpose
Enables PVC autoprovisioning on the range of PVCs.
(Optional) Enables the idle-timeout timer on the on-demand PVC
range.
The default time-out-in-seconds is 0 (no idle-timeout).
The Cisco 10000 series router waits until the traffic on a
particular VC is processed before tearing down the VC, even if
you specify the minimum-traffic-in-kbps option or if the VC is
idle during the idle-timeout period.
enables autoprovisioning on PVC range 100/100 to 100/200 and sets the idle-timeout timer
Enabling ATM PVC Autoprovisioning on a PVC Range
Purpose
Specifies the ATM interface and enters interface or subinterface
configuration mode.
Specifies the range of PVCs and enters atm-range configuration
mode.
Specifies an individual PVC within the PVC range.
Enables PVC autoprovisioning on the individual PVC within the
PVC range.
(Optional) Enables the idle-timeout timer on the on-demand PVC
within the PVC range.
The default time-out-in-seconds is 0 (no idle-timeout).
The Cisco 10000 series router waits until the traffic on a
particular VC is processed before tearing down the VC, even if
you specify the minimum-traffic-in-kbps option or if the VC is
idle during the idle-timeout period.
Chapter 8 Configuring ATM Permanent Virtual Circuit Autoprovisioning
OL-2226-23