Front Bezel - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual
Hp storageworks nas e7000 v2 maintenance and service guide
Hide thumbs
Also See for 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server:
- Release note (30 pages) ,
- Installation manual (29 pages) ,
- Application notes (19 pages)
Table of Contents
Advertisement
Removal and Replacement Procedures
Figure 31: Removing a drive from a slimline drive bay
To replace a slimline drive, slide the drive into the slot until it engages the connector.
Note:
DVD-ROM drive to be bootable, it must be installed in the bottom slimline drive bay.
Front Bezel
To remove the front bezel:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Rack from the Server" in this
3. Remove the rear access panel. Refer to "Opening and Removing the Rear Access Panel"
4. Remove the front access panel. Refer to "Removing the Front Access Panel" in this
5. Remove the light pipe plastic assembly by pressing in the hooks at the panel and rear.
6. Using the T-15 Torx tool, remove the six screws on the exterior of the chassis (1) and the
58
2
For the diskette drive to be bootable, it must be installed in the top slimline drive bay. For the
chapter.
in this chapter.
chapter.
two screws on the interior of the chassis next to the slimline drive bays (2).
1
NAS e7000 v2 Maintenance and Service Guide
Advertisement
Table of Contents
