Pci-X Expansion Board Basket - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual
Hp storageworks nas e7000 v2 maintenance and service guide
Hide thumbs
Also See for 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server:
- Release note (30 pages) ,
- Installation manual (29 pages) ,
- Application notes (19 pages)
Table of Contents
Advertisement
Removal and Replacement Procedures
PCI-X Expansion Board Basket
To remove the PCI-X expansion board basket:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Rack from the Server" in this
3. Open the rear access panel. Refer to "Opening and Removing the Rear Access Panel" in
4. Unplug all cables attached to the expansion board at the rear of the server.
5. Remove all PCI-X Hot Plug expansion boards from the basket. Refer to "PCI and PCI-X
Note:
6. Pull up on the two plastic rivets to disengage them from the front fan cage (1).
7. Pull up on the side of the basket at the front of the server and tilt it up to a 45 angle (2).
8. Slide the entire basket toward the front of the server and lift the basket out of the
Figure 42: Removing the expansion board basket
Reverse steps 1 through 7 to replace the expansion board basket.
66
chapter.
this chapter.
Hot Plug Expansion Boards" in this chapter.
If no expansion board is installed in PCI-X slot 1, remove the expansion slot cover.
chassis (3).
2
3
NAS e7000 v2 Maintenance and Service Guide
1
Advertisement
Table of Contents
