Diagnostics Display Board And Lightpipe - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

Removal and Replacement Procedures
Figure 46: Removing the pass-through board
Reverse steps 1 through 7 to replace the pass-through board connector.

Diagnostics Display Board and Lightpipe

To remove the removable media board:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Server from the Rack" in this
3. Remove the rear access panel. Refer to "Opening and Removing the Rear Access Panel"
4. Remove the front access panel. Refer to "Removing the Front Access Panel" in this
5. Remove the processor air baffle. Refer to "Processor Air Baffle" in this chapter.
6. Remove the front fan cage. Refer to "Front Fan Cage" in this chapter.
7. Remove the pass-through board. Refer to "Pass-Through Board" in this chapter.
8. Eject all devices from the slimline drive bays. Refer to "Slimline Drives" in this chapter.
9. Unplug the Power Button/LED cable. Refer to "Power Button/LED Assembly" in this
10. Loosen the two thumbscrews holding the removable media board (1).
11. Slide the board to the rear of the unit until it stops, and then lift it up (2).
70
chapter.
in this chapter.
chapter.
chapter.
1
2
1
NAS e7000 v2 Maintenance and Service Guide