Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual page 45

Figure 21: Installing a memory board
4. If the server is not currently configured for hot-plug mirrored memory, power up the
5. Configure the memory. Refer to "Configuring the Memory" in this chapter.
6. Reference the LEDs on the top of the memory board to be sure that the memory is
NAS e7000 v2 Maintenance and Service Guide
Hot-replacement procedure: All LEDs now turn off except the memory status LED,
which flashes green while data is copied from one memory board to the other. This
process may take up to a minute to complete. When the copying process is complete, the
other LEDs will re-illuminate as described in Table 2-11.
Caution: Do not remove the memory board while the memory status LED is flashing. When
the memory status LED is flashing, the memory board is transferring data. Removing the
memory board during data transfer may cause system failure.
2
server. Refer to "Powering Down the Server" in this chapter.
Hot-plug procedure: If the server is configured for hot-plug mirrored memory, skip to
step 7.
functioning properly. Table 11
the DIMMs and memory board are installed and functioning properly. For more
information on LEDs, refer to Chapter 4 "Connectors, LEDs, and Switches."
2
1
describes the LEDs for each memory configuration when
Removal and Replacement Procedures
3
45