Enabling Rompaq Disaster Recovery Mode; System Id Switch (Sw7) - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

Connectors, LEDs, and Switches

Enabling ROMPaq Disaster Recovery Mode

A corrupted system ROM requires you to recreate the ROM BIOS by using the ROM flash
utility. This can be accomplished only when the system is in disaster recovery mode. Set
configuration switches 1, 4, 5, and 6 on the system maintenance switch block to on to enable
disaster recovery mode.
Note:
for complete instructions on disaster recovery.

System ID Switch (SW7)

Figure 76
Figure 76: System ID switch (SW7)
Table 34: System ID Switch (SW7)
1 through 3
112
Before enabling ROMPaq disaster recovery mode, refer to the
and Table 34 identify the system ID switch location and settings.
Position Default
Chassis ID
1 2
Function
Used to allow 8 ID
combinations, if used as
another system.
NAS e7000 v2 Maintenance and Service Guide
Servers Troubleshooting Guide
Description Settings