Pci-X Hot Plug Board - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

PCI-X Hot Plug Board

To remove the PCI-X Hot Plugboard:
Note:
board.
1. Extend the server from the rack. Refer to "Extending the Rack from the Server" in this
2. Power down the server. Refer to "Powering Down the Server" in this chapter.
3. Open the rear access panel. Refer to "Opening and Removing the Rear Access Panel" in
4. Remove all PCI-X expansion boards from the basket. Refer to "PCI and PCI-X Hot Plug
Figure 43: Removing the PCI-X Hot Plug board
5.
6. Open the PCI-X latch and remove the PCI-X slot cover.
7. From the back of the server at the top of the PCI-X slot, press upward and then forward
8. Repeat step 8 for the six PCI-X slots and the PCI-X Hot Plug board will be exposed.
Reverse steps 1 through 9 to replace the PCI-X Hot Plug board.
NAS e7000 v2 Maintenance and Service Guide
HP recommends that you remove the server from the rack before removing the PCI-X Hot Plug
chapter.
this chapter.
Expansion Boards" in this chapter.
Unplug the cable at the PCI-X hot-plug board connector on the system board. Refer to
"System Board" in Chapter 4.
with your finger to release the PCI-X latch. From inside the server, lift up on the latch until
it unhooks from the back wall of the server.
2
1
3
Removal and Replacement Procedures
67