Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual page 52

Removal and Replacement Procedures
The NAS e7000 v2 includes six PCI-X expansion slots. Use
each slot.
Figure 26: PCI-X slot locations
Table 12: NAS e7000 v2 PCI-X Expansion Slots and Buses
To remove an expansion board from a PCI-X Hot Plug slot:
1. Extend the server from the rack. Refer to "Extending the Server from the Rack" in this
2. Open the rear access panel. Refer to "Opening and Removing the Rear Access Panel" in
3. Press the port-colored PCI-X Hot Plug button (1) to turn off power to the slot. The power
52
The PCI-X Hot Plug button and the PCI-X Hot Plug Utility enable you to power up or
power down a PCI-X Hot Plug expansion slot. The PCI-X Hot Plug button enables direct
access at each hot-plug expansion slot.
PCI-X Hot Plug software support for each operating system is available online. For more
information, refer to the PCI Hot Plug Administrator's Guide on the Documentation CD.
1
2
3
4
5
6
Item Description
1 Slot 1 (non-hot-plug)
2 Slot 2 (non-hot-plug)
3 Slot 3 (hot-plug)
4 Slot 4 (hot-plug)
5 Slot 5 (hot-plug)
6 Slot 6 (hot-plug)
chapter.
this chapter.
LED flashes until shutdown is complete. Refer to "PCI-X Hot Plug LEDs" in Chapter 4 to
determine the current PCI-X Hot Plug slot status.
Figure 26 and Table 12
Bus
Shared bus 2
Shared bus 6
Shared bus 10
NAS e7000 v2 Maintenance and Service Guide
to identify