Powering Down The Server; Removing The Server From The Rack - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

Powering Down the Server

For all non-hot-plug procedures, you must power down the server. To power down the server:
1. Press and hold the Power On/Standby button until the front panel power LED indicator is
2. Disconnect all AC power cords from the server.
3. Disconnect all external peripheral devices from the server.

Removing the Server from the Rack

To remove the server from the rack:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Loosen the front panel thumbscrews that secure the server faceplate to the front of the
3. Extend the server from the rack. Refer to "Extending the Server from the Rack" in this
4. Remove the cable management system and unplug the cables from the rear of the server.
5. Press the rail release levers on the rails and slide the server off the rack rails.
NAS e7000 v2 Maintenance and Service Guide
WARNING: It is necessary to be knowledgeable of electrostatic discharge information
before preparing the server. For electrostatic discharge information, refer to "Electrostatic
Discharge" in this chapter.
amber and the fans are off.
WARNING: The server is very heavy, up to 44.5 kg (98 lbs). To reduce the risk of personal
injury or damage to the equipment:
Remove all hot-plug power supplies to reduce the weight of the server before lifting it.
Observe local occupational health and safety requirements and guidelines for material
handling.
Get help to lift and maneuver the server.
rack.
chapter.
Removal and Replacement Procedures
31