Installing A Dimm; Installing A Memory Board - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

Removal and Replacement Procedures

Installing a DIMM

To install a DIMM:
1. Align the keyed portion of the bottom edge of the DIMM with the tab in the DIMM slot.
Note:
2. Press the DIMM firmly into the slot (1).
3. Push the latches into place (2).
Figure 20: Installing a DIMM

Installing a Memory Board

To install a memory board:
1. Align the memory board with the memory slot and memory board guide clips.
2. Slide the memory board into the server (1), and close the ejector levers to seat the memory
Note:
you have already replaced the failed DIMM, disregard the amber LEDs. The LEDs change back to
green after the locking switch is engaged, and the memory copy is complete.
3. Engage the locking switch (3).
44
The bottom edge of the DIMM is keyed to fit into the DIMM slot only one way.
2
board firmly (2).
Hot-replacement procedure: Any LEDs that were amber when the board was removed
from the server now illuminate amber again.
The LEDs relight amber during this step to enable you to verify again which DIMM failed. If
1
NAS e7000 v2 Maintenance and Service Guide
1
2