Non-Hot-Plug Pci-X Expansion Boards - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual
Hp storageworks nas e7000 v2 maintenance and service guide
Hide thumbs
Also See for 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server:
- Release note (30 pages) ,
- Installation manual (29 pages) ,
- Application notes (19 pages)
Table of Contents
Advertisement
Removal and Replacement Procedures
Figure 39: Removing the processor/heatsink assembly
Reverse steps 1 through 7 to replace a processor.
Note:
Non-Hot-Plug PCI-X Expansion Boards
To remove a non-hot-plug expansion board:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Rack from the Server" in this
3. Open the rear access panel. Refer to "Opening and Removing the Rear Access Panel" in
4. Disconnect any cables connected to the expansion board.
5. Press the PCI-X retaining clip until it stays in the open position.
64
Caution:
The processor is designed to fit one way into the socket. Align the three holes in
the base of the heatsink with the three positioning pins in the retaining bracket to properly
seat the processor.
Mixing processor speeds and cache sizes is not supported.
Caution:
Before closing the processor retaining bracket, be sure that the processor locking
lever is closed. Forcing the bracket shut may damage the processor or the processor socket.
chapter.
this chapter.
2
1
NAS e7000 v2 Maintenance and Service Guide
Advertisement
Table of Contents
