Pass-Through Board - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

8. Remove the PCI-X expansion boards. Refer to "Non-Hot-Plug PCI-X Expansion Boards"
9. Remove the PCI-X basket. Refer to "PCI-X Expansion Board Basket" in this chapter.
10. Remove the SCSI cables. Refer to "SCSI Cables" in this chapter.
11. Loosen the three thumbscrews that secure the front fan cage to the chassis (1).
12. Lift the front fan cage from the chassis (2).
Figure 45: Removing the front fan cage
Reverse steps 1 through 12 to replace the front fan cage.

Pass-Through Board

To remove the pass-through board:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Rack from the Server" in this
3. Remove the rear access panel. Refer to "Opening and Removing the Rear Access Panel"
4. Remove the front access panel. Refer to "Removing the Front Access Panel" in this
5. Remove the front fan cage. Refer to "Front Fan Cage" in this chapter.
6. Loosen the two thumbscrews that secure the pass-through board to the removable media
7. Lift the pass-through board straight up and out of the chassis (2).
NAS e7000 v2 Maintenance and Service Guide
in this chapter.
chapter.
in this chapter.
chapter.
board and the side chassis wall (1). You may need to use a Torx T-15 screwdriver.
2
Removal and Replacement Procedures
1
69