Processor Power Modules - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

Figure 35: Removing the processor air baffle
Reverse steps 1 through 6 to replace the processor air baffle.

Processor Power Modules

1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Rack from the Server" in this
3. Open the rear access panel. Refer to "Opening and Removing the Rear Access Panel" in
4. Remove the memory board from slot 1. Refer to "Removing a Memory Board" in this
5. Remove the processor air baffle. Refer to "Processor Air Baffle" in this chapter.
6. Loosen the thumbscrew on the processor retaining bracket (1).
7. Open the processor retaining bracket (2).
NAS e7000 v2 Maintenance and Service Guide
1
Caution: Before installing the Processor Power Module (PPM), make sure that the part
number on the PPM matches the part number on an existing PPM in the system. PPMs with
the same part number may look different, but are functionally equivalent.
chapter.
this chapter.
chapter.
2
Removal and Replacement Procedures
1
61