Configuring The Memory - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

Removal and Replacement Procedures
Table 11: Memory LED States on a Properly Configured Memory Board
Memory Status
Mirroring Status
Online Spare text*
Ready to Hot Plug
*If two memory boards are installed, the online spare text is only illuminated for the memory
board in slot 1.
7. Close the rear access panel.
8. Reinstall the server in the rack.

Configuring the Memory

Configuring the servers memory system of the server requires configuring both hardware and
software. To configure the memory:
1. Choose one of the following memory configurations:
2. Remove the memory board. Refer to "Removing a Memory Board" in this chapter.
3. Install the required DIMMs based on your desired memory configuration. Be sure to
4. Install the memory board. Refer to "Installing a Memory Board" in this chapter.
5. Configure the DIMMs:
46
LED
Advanced ECC
(Standard
Memory)
Green
DIMMs 1-8, if Green
populated
Online Spare Off
Status
Off
Off
Off
Standard memory (Advanced ECC)
Online spare memory
Single board mirrored memory
Hot-plug mirrored memory
For a discussion of how to determine the memory technology best suited for your
requirements, refer to the Advanced Memory Protection white paper on the HP website at
.
www.hp.com
follow all DIMM installation requirements. Refer to "DIMM Installation Requirements"
in this chapter for your desired memory configuration.
a. Power on the server.
b. Press the F9 key to enter RBSU.
c. Select Advanced Options.
d. Change POST Speed Up to disable (to test the replaced memory).
Memory Configuration
Online Single-Board
Spare Mirrored
Memory Memory
Green Green
Green Green
Green Off
Off Green
Green Off
Off Off
NAS e7000 v2 Maintenance and Service Guide
Hot-Plug
Mirrored
Memory
Green
Green
Off
Green
Off
Green