Pci And Pci-X Hot Plug Expansion Boards - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

To remove a hot-plug power supply:
1. Remove any shipping screws from the bottom of the server, if installed.
2. Press the lever-release button on the handle of the power supply (1).
3. Pull on the lever to release the power supply (2).
4. Remove the power supply from the server (3).
Figure 25: Removing a hot-plug power supply
Reverse steps 1 through 4 to replace a hot-plug power supply.

PCI and PCI-X Hot Plug Expansion Boards

Use either the PCI-X Hot Plug button on the server or the PCI-X Hot Plug Utility of the
operation system to control the PCI-X Hot Plug slots.
NAS e7000 v2 Maintenance and Service Guide
Caution: Hot-plug power supplies for the NAS e7000 v2 are keyed to be sure that only
800-W hot-plug power supplies can be installed in the server. The handles on 800-W
power supplies are black to distinguish them from other power supplies.
1
Caution: Do not attempt a PCI-X Hot Plug procedure if the operating system does not
provide PCI-X Hot Plug support or if you do not have the appropriate device drivers
installed. Failure to take these precautions causes system shutdown and risks data integrity.
To avoid critical errors, do not open the expansion slot latch if the green power
Caution:
LED is on or blinking. Use the PCI-X Hot Plug button or the software application to turn off
power to the slot.
Removal and Replacement Procedures
2
3
51