Power Button/Led Assembly; Processor Air Baffle - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

Removal and Replacement Procedures

Power Button/LED assembly

To remove the power button/LED assembly:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Rack from the Server" in this
3. Remove the rear access panel. Refer to "Opening and Removing the Rear Access Panel"
4. Remove the front access panel. Refer to "Removing the Front Access Panel" in this
5. Unplug the cable from the removable media board (1).
6. Push on the locking tab until the opposite side comes out (2).
Figure 34: Removing the power button/LED assembly
Reverse steps 1 through 6 to replace the power button/LED assembly.

Processor Air Baffle

To remove the processor air baffle:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Rack from the Server" in this
3. Open the rear access panel. Refer to "Opening and Removing the Rear Access Panel" in
4. Remove memory board 1. Refer to "Removing a Memory Board" in this chapter.
5. Squeeze both ends of the baffle to release the tabs (1).
6. Lift the processor air baffle from the chassis (2).
60
chapter.
in this chapter.
chapter.
2
chapter.
this chapter.
1
NAS e7000 v2 Maintenance and Service Guide