Scsi Backplane - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Maintenance And Service Manual

11. Using your fingernail, release the latch that connects each side of the 5i Plus Memory
12. Disengage the BBWC enabler from the standoffs on the side of the chassis. Remove the
Figure 49: Removing the BBWC enabler and 5i Plus Memory Module
Reverse steps 1 through 12 to replace the BBWC enabler and 5i Plus Memory Module.

SCSI Backplane

To remove the SCSI backplane:
1. Extend the server from the rack. Refer to "Extending the Rack from the Server" in this
2. Power down the server. Refer to "Powering Down the Server" in this chapter.
3. Unseat all the hot-plug SCSI hard drives and pull them away from the SCSI backplane.
Note:
installed in the same slot.
4. Remove the rear access panel. Refer to "Opening and Removing the Rear Access Panel"
NAS e7000 v2 Maintenance and Service Guide
Module to the system board until the module rises away from the system board (1).
Caution: Do not disconnect the cable connecting the BBWC enabler and the 5i Plus
Memory Module.
complete assembly from the server by pushing it from under the printed circuit board at
the standoff (2).
1
2
chapter.
Refer to "Hot-Plug SCSI Hard Drives" in this chapter.
If you plan to take the hard drives out of the drive cage, label them so that they will be
in this chapter.
3
1
Removal and Replacement Procedures
73