Verifying That Cisco Unified Srst Is Enabled - Cisco CP-7911G-CH1 System Administrator Manual

Setting Up Cisco Unified IP Phones using SCCP
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
ephone-type phone-type
Example:
Router(config)# ephone-type 8941
Step 4
device-id number
Example:
Router(config-ephone-type)# device-id 586
Step 5
device-type phone-type
Example:
Router(config-ephone-type)# device-type 8941
Step 6
end
Example:
Router(config-ephone-type)# end

Verifying That Cisco Unified SRST Is Enabled

To verify that the Cisco Unified SRST feature is enabled, perform the following steps:
Enter the show running-config command to verify the configuration.
Step 1
Enter the show call-manager-fallback all command to verify that the Cisco Unified SRST feature is
Step 2
enabled.
Use the Settings display on the Cisco IP phones in your network to verify that the default router IP
Step 3
address on the phones matches the IP address of the Cisco Unified SRST router.
OL-13143-04
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enters phone type to configure.
8941
•
8945
•
Specifies the device ID for the phone type.
8941—586
•
8945—585
•
Specifies the device type for the phone.
8941
•
8945
•
Exits to privileged EXEC mode.
Cisco Unified SCCP and SIP SRST System Administrator Guide
How to Set Up Cisco Unified IP Phones
89