Configuration Examples For Sccp Srst; Configuring Local Voice-Mail System (Fxo And Fxs): Example - Cisco CP-7911G-CH1 System Administrator Manual

Integrating Voice Mail with Cisco Unified SRST
Command
Step 6
mwi-server {ipv4:destination-address |
dns:host-name} [expires seconds] [port port]
[transport {tcp | udp}] [unsolicited]
Example:
Router(config-sip-ua)# mwi-server ipv4:10.0.2.254
Step 7
exit
Example:
Router(config-sip-ua)# exit

Configuration Examples for SCCP SRST

This section provides the following configuration examples:
•
•
•
•

Configuring Local Voice-Mail System (FXO and FXS): Example

The "Dial-Peer Configuration for Integration of Voice-Mail with Cisco Unified SCCP SRST" section of
the example below shows a legacy dial-peer configuration for a local voice-mail system. The "Cisco
Unified SCCP SRST Voice-Mail Integration Pattern Configuration" section must be compatible with
your voice-mail system configuration.
OL-13143-04
Configuring Local Voice-Mail System (FXO and FXS): Example, page 249
Configuring Central Location Voice-Mail System (FXO and FXS): Example, page 250
Configuring Voice-Mail Access over FXO and FXS: Example, page 251
Configuring Voice-Mail Access over BRI and PRI: Example, page 251
Purpose
Configures voice-mail server settings on a voice
gateway or user agent. The IP address and port for the
SIP-based MWI server should be in the same LAN as
the voice-mail server. The MWI server is a
Cisco Unified SCCP SRST router. Keywords and
arguments are as follows:
ipv4:destination-address: IP address of the
•
voice-mail server.
• dns:host-name: The argument should contain the
complete hostname to be associated with the
target address; for example, dns:test.cisco.com.
expires seconds: Subscription expiration time, in
•
seconds. Range is from 1 to 999999. Default
is 3600.
port port: Port number on the voice-mail server.
•
Default is 5060.
transport: Transport protocol to the voice-mail
•
server. Valid values are tcp and udp. Default is
UDP.
• unsolicited: Requires the voice-mail server to
send a SIP notification message to the voice
gateway or UA if the mailbox status changes.
Removes the requirement that the voice gateway
subscribe for MWI service.
Exits SIP user-agent configuration mode.
Cisco Unified SCCP and SIP SRST System Administrator Guide
Configuration Examples for SCCP SRST
249