Setting Up Cisco Unified Ip Phones Using Sccp; Contents; Information About Setting Up Cisco Unified Ip Phones - Cisco CP-7911G-CH1 System Administrator Manual

Setting Up Cisco Unified IP Phones using SCCP

Revised: April 23, 2012
This chapter describes how to set up the displays and features that callers will see and use on Cisco
Unified IP Phones during Cisco Unified CM fallback.
Note Ciso Unified IP Phones discussed in this chapter are just examples. For a complete list of IP phones, see
Compatibility Information.

Contents

•
•
•
•

Information About Setting Up Cisco Unified IP Phones

Cisco Unified IP Phone configuration is limited for Cisco Unified SRST because IP phones retain nearly
all Cisco Unified CM settings during Cisco Unified CM fallback. You can configure the date format,
time format, language, and system messages that appear on Cisco Unified IP Phones during
Cisco Unified Communications Manager fallback. All four of these settings have defaults, and the
available language options depend on the IP phones and Cisco Unified CM version in use. Also available
for configuration is a secondary dial tone, which can be generated when a phone user dials a predefined
PSTN access prefix and can be terminated when additional digits are dialed. Dual-line phone
configuration is required for dual-line phone operation during Cisco Unified CM fallback.
OL-13143-04
Information About Setting Up Cisco Unified IP Phones, page 85
How to Set Up Cisco Unified IP Phones, page 86
How to Set Up Cisco IP Communicator for Cisco Unified SRST, page 102
Where to Go Next, page 103
Cisco Unified SCCP and SIP SRST System Administrator Guide
85