How To Set Video Parameters For Cisco Unified Srst; Configuring Slow Connect Procedures - Cisco CP-7911G-CH1 System Administrator Manual

Setting Video Parameters
To display information about RTP named-event packets, such as caller-ID number, IP address, and port
for both the local and remote endpoints, use the show voip rtp connection command as shown in the
following sample output:
Router# show voip rtp connections
VoIP RTP active connections :
No. CallId
1
2
Found 2 active RTP connections
============================

How to Set Video Parameters for Cisco Unified SRST

When the Cisco Unified SRST is enabled, Cisco Unified IP phones do not have to be reconfigured for
video capabilities because all ephones retain the same configuration used with Cisco Unified CM.
However, you can set video parameters for Cisco Unified SRST.
Setting Video parameters for Cisco Unified SRST involves the following tasks:
•
•
•

Configuring Slow Connect Procedures

Video streams require slow-connect procedures for Cisco Unified SRST. H.323 endpoints require a slow
connect because the endpoint-capability match occurs after the connect message.
Note For more information about slow-connect procedures, see
Use the following procedure to configure slow-connect procedures.
SUMMARY STEPS
1.
2.
3.
4.
5.
OL-13143-04
dstCallId LocalRTP RmtRTP LocalIP
102 103 18714
105 104 17252
Configuring Slow Connect Procedures, page 261
Verifying Cisco Unified SRST, page 262
Setting Video Parameters for Cisco Unified SRST, page 268
enable
configure terminal
voice service voip
h323
call start slow
How to Set Video Parameters for Cisco Unified SRST
18158 10.1.1.1
19088 10.1.1.1
Configuring Quality of Service for
Cisco Unified SCCP and SIP SRST System Administrator Guide
RemoteIP
192.168.1.1
192.168.1.1
Voice.
261