Cisco CP-7911G-CH1 System Administrator Manual page 133

Configuring Call Handling
The default phone load on Cisco Unified Communications Manager, Release 4.0(1) for the Cisco 7905
Note
and Cisco 7912 IP phones does not enable the PickUp soft key during fallback. To enable the PickUp
soft key on Cisco 7905 and Cisco 7912 IP phones, upgrade your default phone load to 
Cisco Unified CM, Version 4.0(1) Sr2. Alternatively, you can upgrade the phone load to
cmterm-7905g-sccp.3-3-8.exe
SUMMARY STEPS
1.
2.
3.
4.
5.
DETAILED STEPS
Command or Action
Step 1
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 2
no huntstop
Example:
Router(config-cm-fallback)# no huntstop
Step 3
alias tag number-pattern to alternate-number
Example:
Router(config-cm-fallback)# alias 1 8005550100
to 5001
OL-13143-04
call-manager-fallback
no huntstop
alias tag number-pattern to alternate-number
pickup telephone-number
end
or cmterm-7912g-sccp.3-3-8.exe, respectively.
Purpose
Enters call-manager-fallback configuration mode.
Disables huntstop.
Creates a set rules for rerouting calls to sets of phones that
are unavailable during Cisco Unified CM fallback.
tag: Identifier for alias rule range. The range is from 1
•
to 50.
number-pattern: Pattern to match the incoming
•
telephone number. This pattern may include wildcards.
to: Connects the tag number pattern to the alternate
•
number.
alternate-number: Alternate telephone number to
•
route incoming calls to match the number pattern. The
alternate number has to be a specific extension that
belongs to an IP phone that is actively registered on the
Cisco Unified SRST router. The alternate telephone
number can be used in multiple alias commands.
Cisco Unified SCCP and SIP SRST System Administrator Guide
How to Configure Cisco Unified SCCP SRST
133