Cisco CP-7911G-CH1 System Administrator Manual page 276

How to Configure Cisco Unified SIP SRST Features Using Redirect Mode
Configuring Call Redirect Enhancements to Support Calls on a Specific VoIP Dial Peer
To enable IP-to-IP call redirection for a specific VoIP dial peer, configure it on an inbound dial peer in
dial-peer configuration mode. The default application on Cisco Unified SIP SRST supports IP-to-IP
redirection.
When IP-to-IP redirection is configured in dial-peer configuration mode, the configuration for the
Note
specific dial peer takes precedence over the global configuration entered under voice service
configuration mode.
Restrictions
The redirect ip2ip command must be configured on an inbound dial peer of the gateway.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
dial-peer voice tag voip
Example:
Router(config)# dial-peer voice 25 voip
Cisco Unified SCCP and SIP SRST System Administrator Guide
276
enable
configure terminal
dial-peer voice tag voip
application application-name
redirect ip2ip
end
Appendix A: Configuring Cisco Unified SIP SRST Features Using Redirect Mode
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Enters dial-peer configuration mode.
• tag—A number that uniquely identifies the dial peer
(this number has local significance only).
• voip—Indicates that this is a VoIP peer using voice
encapsulation on the POTS network and is used for
configuring redirect.
OL-13143-04