Cisco CP-7911G-CH1 System Administrator Manual page 301

Appendix B: Integrating Cisco Unified Communications Manager and Cisco Unified SRST to Use Cisco Unified SRST
Verifying Basic Cisco Unified SRST Multicast MOH Streaming
Use the following procedure to verify that multicast MOH packets are configured with the multicast
moh command.
SUMMARY STEPS
1.
2.
3.
DETALED STEPS
Command or Action
Step 1
debug ephone moh
Example:
Router# debug ephone moh
!
MOH route If FastEthernet0/0 ETHERNET 172.21.51.143
via ARP
MOH route If Loopback0 46 172.21.51.98 via
172.21.51.98
!
Step 2
show interfaces fastethernet
Example:
Router# show interfaces fastethernet 0/0
!
30 second output rate 86000 bits/sec, 50 packets/sec
!
Step 3
show ephone summary
Example:
Router# show ephone summary
!
File music-on-hold.au type AU
Media_Payload_G.711Ulaw64k
!
Troubleshooting Tips
The show ephone summary output should show a file type as either .au or .wav. If INVALID appears,
an error exists.
Router# show ephone summary
!
File music-on-hold.au type INVALID Media_Payload_G.711Ulaw64k
!
OL-13143-04
debug ephone moh
show interfaces fastethernet
show ephone summary
160 bytes
How to Use Cisco Unified SRST Gateways as a Multicast MOH Resource
Purpose
This command sets debugging for MOH. You can
use this command to show that the
Cisco Unified SRST gateway is multicasting MOH
out of Loopback 0 and Fast Ethernet 0/0.
Use this command to confirm that the interface
output rates match one G.711 stream, which the
show interfaces fastethernet output displays as
50 packets/sec and 80 kbps or more.
Use this command to verify that the Cisco IOS
software was able to read the MOH audio file
successfully.
Cisco Unified SCCP and SIP SRST System Administrator Guide
160 bytes651-
301