Cisco CP-7911G-CH1 System Administrator Manual page 159

Configuring Call Handling
a Cisco Unified SRST router and try to make a call from that phone, the call will be considered an
incoming call to the router and voice port. If you make a call to the FXS phone, the call will be
considered outgoing.
By default, an incoming call leg has the highest COR priority; the outgoing call leg has the lowest
priority. If there is no COR configuration for incoming calls on a dial peer, you can make a call from a
phone attached to the dial peer, so that the call will go out of any dial peer regardless of the COR
configuration on that dial peer.
configured.
Table 2
COR List on Incoming
Dial Peer
No COR
No COR
COR list applied for
incoming calls
COR list applied for
incoming calls
(superset of COR list
applied for outgoing
calls on the outgoing
dial peer)
COR list applied for
incoming calls
(subset of COR list
applied for outgoing
calls on the outgoing
dial peer)
SUMMARY STEPS
1.
2.
3.
OL-13143-04
Combinations of COR List and Results
COR List on Outgoing
Dial Peer
No COR
COR list applied for
outgoing calls
No COR
COR list applied for
outgoing calls
(subsets of COR list
applied for incoming
calls on the incoming
dial peer)
COR list applied for
outgoing calls
(supersets of COR list
applied for incoming
calls on the incoming
dial peer)
call-manager-fallback
cor {incoming | outgoing} cor-list-name {cor-list-number starting-number - ending-number |
default}
exit
Table 2 describes call functionality based on how your COR lists are
Result
Call will succeed.
Call will succeed. By default, the incoming dial peer
has the highest COR priority when no COR is applied.
If you apply no COR for an incoming call leg to a dial
peer, the dial peer can make a call out of any other dial
peer regardless of the COR configuration on the
outgoing dial peer.
Call will succeed. By default, the outgoing dial peer
has the lowest priority. Because there are some COR
configurations for incoming calls on the incoming or
originating dial peer, it is a superset of the outgoing
call's COR configuration for the outgoing or
terminating dial peer.
Call will succeed. The COR list for incoming calls on
the incoming dial peer is a superset of the COR list for
outgoing calls on the outgoing dial peer.
Call will not succeed. The COR list for incoming calls
on the incoming dial peer is not a superset of the COR
list for outgoing calls on the outgoing dial peer.
Cisco Unified SCCP and SIP SRST System Administrator Guide
How to Configure Cisco Unified SCCP SRST
159