Cisco CP-7911G-CH1 System Administrator Manual page 204

How to Configure Secure Unified SRST
Figure 3
To add the new SRST reference, click Insert. The message "Status: Insert completed" displays.
Step 4
To add more SRST references, repeat Steps 2 to 4.
Step 5
Configuring SRST Fallback on Cisco Unified Communications Manager
The following procedure describes how to configure SRST fallback on Cisco Unified Communications
Manager by assigning the device pool to SRST.
For complete information about adding a device pool to Cisco Unified Communications Manager, see
the "Device Pool Configuration" section in Cisco Unified Communications Manager Administration
Guide for the Cisco Unified Communications Manager version that you are running. All Cisco Unified
CM administration guides are at the following URL:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_maintenance_guides_list.html
In the menu bar in Cisco Unified Communications Manager, choose CCMAdmin > System > Device
Step 1
Pool.
Use one of the following methods to add a device pool:
Step 2
•
•
In the upper, right corner of the window, click the Add New Device Pool link. The Device Pool
Step 3
Configuration window displays (see
Cisco Unified SCCP and SIP SRST System Administrator Guide
204
SRST Reference Configuration Window
If a device pool already exists with settings that are similar to the one that you want to add, choose
the existing device pool to display its settings, click Copy, and modify the settings as needed.
Continue with Step 4.
To add a device pool without copying an existing one, continue with
Figure 4).
Configuring Secure SRST for SCCP and SIP
Step 3.
OL-13143-04