Cisco CP-7911G-CH1 System Administrator Manual page 145

Configuring Call Handling
DETAILED STEPS
Command or Action
Step 1
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 2
huntstop [channel]
Example:
Router(config-cm-fallback)# huntstop channel
Step 3
exit
Example:
Router(config-cm-fallback)# exit
Examples
The following example disables dial-peer hunting during Cisco Unified CM fallback and hunting to the
secondary channels in dual-line phone configurations:
call-manager-fallback
no huntstop channel
Configuring Busy Timeout
This task sets the timeout value for call transfers to busy destinations. The busy timeout value is the
amount of time that can elapse after a transferred call reaches a busy signal before the call is
disconnected.
SUMMARY STEPS
1.
2.
3.
OL-13143-04
call-manager-fallback
timeouts busy seconds
exit
How to Configure Cisco Unified SCCP SRST
Purpose
Enters call-manager-fallback configuration mode.
Sets the huntstop attribute for the dial peers associated with
the Cisco Unified IP Phone dial peers created during
Communications Manager fallback.
For dual-line configurations, the channel keyword
•
keeps incoming calls from hunting to the second
channel if the first channel is busy or does not answer.
Exits call-manager-fallback configuration mode.
Cisco Unified SCCP and SIP SRST System Administrator Guide
145