Cisco CP-7911G-CH1 System Administrator Manual page 150

How to Configure Cisco Unified SCCP SRST
DETAILED STEPS
Command or Action
Step 1
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 2
call-forward pattern pattern
Example:
Router(config-cm-fallback)# call-forward
pattern 4...
Step 3
transfer-system {blind | full-blind |
full-consult | local-consult}
Example:
Router(config-cm-fallback)# transfer-system
full-consult
Step 4
transfer-pattern transfer-pattern
Example:
Router(config-cm-fallback)# transfer-pattern
52540..
Step 5
exit
Example:
Router(config-cm-fallback)# exit
Cisco Unified SCCP and SIP SRST System Administrator Guide
150
Purpose
Enters call-manager-fallback configuration mode.
Specifies the H.450.3 standard for call forwarding.
• pattern: Digits to match for call forwarding using the
H.450.3 standard. If an incoming calling-party number
matches the pattern, it can be forwarded using the
H.450.3 standard. A pattern of .T forwards all calling
parties using the H.450.3 standard.
Not supported if the transfer-to destination is on the Cisco
ATA, Cisco VG224, or an SCCP-controlled FXS port.
Defines the call-transfer method for all lines served by the
Cisco Unified SRST router.
blind: Calls are transferred without consultation with a
•
single phone line using the Cisco proprietary method.
We do not recommend the blind keyword. Use
Note
either the full-blind or full-consult keyword
instead.
full-blind: Calls are transferred without consultation
•
using H.450.2 standard methods.
full-consult: Calls are transferred with consultation
•
using a second phone line if available. The calls fall
back to full-blind if the second line is unavailable.
local-consult: Calls are transferred with local
•
consultation using a second phone line if available. The
calls fall back to blind for nonlocal consultation or
nonlocal transfer target.
Allows transfer of telephone calls by Cisco Unified IP
Phones to specified phone number patterns.
• transfer-pattern: String of digits for permitted call
transfers. Wildcards are allowed.
Exits call-manager-fallback configuration mode.
Timesaver Before exiting call-manager-fallback
configuration mode, configure any other
parameters that you need to set for the entire
Cisco Unified SRST phone network.
Configuring Call Handling
OL-13143-04