Cisco CP-7911G-CH1 System Administrator Manual page 238

How to Integrate Voice Mail with Cisco Unified SCCP and SIP SRST
DETAILED STEPS
Command or Action
Step 1
dial-peer voice tag {pots | voatm | vofr |
voip}
Example:
Router(config)# dial-peer voice 1002 pots
Step 2
destination-pattern [+] string [T]
Example:
Router(config-dial-peer)# destination-pattern
1100T
Step 3
port {slot-number/subunit-number/port |
slot/port:ds0-group-no}
Example:
Router(config-dial-peer)# port 1/1/1
Cisco Unified SCCP and SIP SRST System Administrator Guide
238
Integrating Voice Mail with Cisco Unified SRST
Purpose
(FXO or FXS and BRI or PRI) Defines a particular dial peer,
specifies the method of voice encapsulation, and enters
dial-peer configuration mode. The dial-peer command
provides different syntax for individual routers. This example is
syntax for Cisco 3600 series routers.
tag: Digits that define a particular dial peer. Range is from
•
1 to 2147483647.
pots: Indicates that this is a POTS dial peer that uses VoIP
•
encapsulation on the IP backbone.
voatm: Specifies that this is a VoATM dial peer that uses
•
real-time AAL5 voice encapsulation on the ATM backbone
network.
• vofr: Specifies that this is a VoFR dial peer that uses
FRF.11 encapsulation on the Frame Relay backbone
network.
voip: Indicates that this is a VoIP dial peer that uses voice
•
encapsulation on the POTS network.
(FXO or FXS and BRI or PRI) Specifies either the prefix or the
full E.164 telephone number (depending on your dial plan) to
be used for a dial peer.
+: (Optional) Character that indicates an E.164 standard
•
number.
string: See Table 1.
•
T: (Optional) Control character that indicates that the
•
destination-pattern value is a variable-length dial string.
(FXO or FXS and BRI or PRI) Associates a dial peer with a
specific voice port on Cisco 3600 series routers.
slot-number: Number of the slot in the router in which the
•
voice interface card (VIC) is installed. Valid entries are
from 0 to 3, depending on the slot in which it is installed.
subunit-number: Subunit on the VIC in which the voice
•
port is located. Valid entries are 0 or 1.
port: Voice port number. Valid entries are 0 and 1.
•
ds0-group-no: Specifies the DS0 group number. Each
•
defined DS0 group number is represented on a separate
voice port. This allows you to define individual DS0s on
the digital T1/E1 card.
OL-13143-04