Cisco CP-7911G-CH1 System Administrator Manual page 111

Setting Up Cisco Unified IP Phones using SIP
Command or Action
Step 7
proxy ip-address [preference value] [monitor
probe {icmp-ping | rtr} [alternate-ip-address]]
Example:
Router(config-register-pool)# proxy
10.2.161.187 preference 1
Step 8
voice-class codec tag
Example:
Router(config-register-pool)# voice-class codec
15
Step 9
application application-name
Example:
Router(config-register-pool)# application
SIP.App
Step 10
end
Example:
Router(config-register-pool)# end
What to Do Next
There are several more voice register pool commands that add functionality, but that are not required.
See the
page 112
OL-13143-04
"Configuring Backup Registrar Service to SIP Phones (Using Optional Commands)" section on
for these commands.
Purpose
Autogenerates additional VoIP dial peers to reach the main
SIP proxy whenever a Cisco Unified SIP IP Phone registers
with a Cisco Unified SIP SRST gateway. The keywords and
arguments are defined as follows:
ip-address: IP address of the SIP proxy.
•
preference value: (Optional) Defines the preference of
•
the proxy dial peers that are created. The preference
must be less (higher priority) than the preference
configured with the preference command.
Range is from 0 to 10. The highest preference is 0.
There is no default.
• monitor probe: (Optional) Enables monitoring of
proxy dial peers.
icmp-ping: Enables monitoring of proxy dial peers
•
using ICMP ping.
The dial peer on which the probe is configured will
Note
be excluded from call routing only for outbound
calls. Inbound calls can arrive through this dial peer.
rtr: Enables monitoring of proxy dial peers using RTR
•
probes.
alternate-ip-address: (Optional) Enables monitoring of
•
alternate IP addresses other than the proxy address. For
example, to monitor a gateway front end to a SIP proxy.
Sets the voice class codec parameters. The tag argument is
a codec group number between 1 and 10000.
(Optional) Selects the session-level application on the VoIP
dial peer. Use the application-name argument to define a
specific interactive voice response (IVR) application.
Returns to privileged EXEC mode.
Cisco Unified SCCP and SIP SRST System Administrator Guide
How to Configure the SIP Registrar
111