Configuring Outgoing Calls - Cisco CP-7911G-CH1 System Administrator Manual

Configuring Call Handling
DETAILED STEPS
Command or Action
Step 1
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 2
timeouts ringing seconds
Example:
Router(config-cm-fallback)# timeouts ringing 30
Step 3
exit
Example:
Router(config-cm-fallback)# exit
Examples
The following example sets the ringing timeout default to 30 seconds:
call-manager-fallback
timeouts ringing 30

Configuring Outgoing Calls

Outgoing call configuration can include the following tasks:
•
•
•
•
•
Configuring Local and Remote Call Transfer
You must configure Cisco Unified SRST to allow Cisco Unified IP Phones to transfer telephone calls
from outside the local IP network to another Cisco Unified IP Phone. By default, all Cisco Unified IP
Phone directory numbers or virtual voice ports are allowed as transfer targets. A maximum of 32 transfer
patterns can be entered.
Call transfer configuration is performed using the transfer-pattern command.
OL-13143-04
Configuring Call Transfer
Configuring Local and Remote Call Transfer, page 147
–
Enabling Consultative Call Transfer and Forward Using H.450.2 and H.450.3 with Cisco SRST
–
3.0, page 148 (Optional)
Enabling Analog Transfer Using Hookflash and the H.450.2 Standard with Cisco SRST 3.0 or
–
Earlier, page 152 (Optional)
Configuring Trunk Access Codes, page 156
Configuring Interdigit Timeout Values, page 157
Configuring Class of Restriction, page 158
Call Blocking (Toll Bar) Based on Time of Day and Day of Week or Date, page 162
How to Configure Cisco Unified SCCP SRST
Purpose
Enters call-manager-fallback configuration mode.
Sets the ringing timeout default, in seconds. The range is
from 5 to 60000. There is no default value.
Exits call-manager-fallback configuration mode.
(Optional)
(Required Under Certain Conditions)
(Optional)
(Optional)
Cisco Unified SCCP and SIP SRST System Administrator Guide
(Optional)
147