Cisco CP-7911G-CH1 System Administrator Manual page 136

How to Configure Cisco Unified SCCP SRST
Configuring Transfer Digit Collection Method
By default, transfer digits are collected from the new call leg. To change the transfer digit collection
method, perform the following steps.
Prerequisites for Cisco Unified SRST 4.3
•
•
•
Restrictions for Cisco Unified SRST 4.3
•
SUMMARY STEPS
1.
2.
3.
4.
5.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 4
transfer-digit-collect {new-call | orig-call}
Example:
Router(config-cm-fallback)#
transfer-digit-collect orig-call
Cisco Unified SCCP and SIP SRST System Administrator Guide
136
Cisco Unified SRST 4.3
Cisco Unified CM 6.0
Cisco IOS Release 12.4(15)XZ
The Cisco 3200 Series Mobile Access Router does not support SRST.
enable
configure terminal
call-manager-fallback
transfer-digit-collect {new-call | orig-call}
end
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enters call-manager-fallback configuration mode.
Selects the digit-collection method used for consultative
call transfers.
new-call: Digits are collected from the new call leg.
•
orig-call: Digits are collected from the original
•
call-leg. This was the default behavior in versions
before Cisco Unified SRST 4.3.
Configuring Call Handling
OL-13143-04