Configuring Cisco Unified Communications Manager To The Secure Cisco Unified Srst Router - Cisco CP-7911G-CH1 System Administrator Manual

Configuring Secure SRST for SCCP and SIP
Configuring Cisco Unified Communications Manager to the Secure Cisco
Unified SRST Router
The following tasks are performed in Cisco Unified Communications Manager:
•
•
•
Adding an SRST Reference to Cisco Unified Communications Manager
The following procedure describes how to add an SRST reference to Cisco Unified Communications
Manager.
Before following this procedure, verify that credentials service is running in the Cisco Unified SRST
Router. Cisco Unified Communications Manager connects to the Cisco Unified SRST Router for its
device certificate. To enable credentials service, see the
Cisco Unified SRST Router" section on page
For complete information on adding Cisco Unified SRST to Cisco Unified Communications Manager,
see the "Survivable Remote Site Telephony Configuration" section for the Cisco Unified
Communications Manager version that you are running. All Cisco Unified CM administration guides are
at the following URL:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_maintenance_guides_list.html.
In the menu bar in Cisco Unified Communications Manager, choose CCMAdmin > System > SRST.
Step 1
Step 2 Click Add New SRST Reference.
Step 3 Enter the appropriate settings.
window.
a.
b.
c.
OL-13143-04
Adding an SRST Reference to Cisco Unified Communications Manager, page 203
Configuring SRST Fallback on Cisco Unified Communications Manager, page 204
Configuring CAPF on Cisco Unified Communications Manager, page 205
Enter the name of the SRST gateway, the IP address, and the port.
Check the box asking if the SRST gateway is secure.
Enter the certificate provider (credentials service) port number. Credentials service runs on default
port 2445.
"Enabling Credentials Service on the Secure
193.
Figure 3 shows the available fields in the SRST Reference Configuration
Cisco Unified SCCP and SIP SRST System Administrator Guide
How to Configure Secure Unified SRST
(required)
(required)
(required)
203