Cisco CP-7911G-CH1 System Administrator Manual page 299

Appendix B: Integrating Cisco Unified Communications Manager and Cisco Unified SRST to Use Cisco Unified SRST
Command or Action
Step 9
ip source-address ip-address [port port]
Example:
Router(config-cm-fallback)# ip source-address
172.21.51.143 port 2000
Step 10
max-ephones max-phones
Example:
Router(config-cm-fallback)# max-ephones 1
Step 11
max-dn max-directory-number
Example:
Router(config-cm-fallback)# max-dn 1
Step 12
moh filename
Example:
Router(config-cm-fallback)# moh music-on-hold.au
Step 13
multicasting-enabled
OL-13143-04
How to Use Cisco Unified SRST Gateways as a Multicast MOH Resource
Purpose
(Optional if the route keyword is not used in the
multicast moh command. See Step 13.) Enables a
router to receive messages from Cisco Unified IP
phones through the specified IP addresses and
ports.
ip-address—The pre-existing router IP
•
address, typically one of the addresses of the
Ethernet port of the router.
• port port—(Optional) The port to which the
gateway router connects to receive messages
from the Cisco Unified IP phones. The port
number range is from 2000 to 9999. The
default port number is 2000.
Configures the maximum number of
Cisco Unified IP phones that can be supported by
a router.
max-phones—Maximum number of Cisco IP
•
phones supported by the router. The
maximum number is platform-dependent. The
default is 0.
Sets the maximum possible number of virtual
voice ports that can be supported by a router.
max-directory-number—Maximum number
•
of directory numbers or virtual voice ports
supported by the router. The maximum
possible number is platform-dependent. The
default is 0.
Enables use of an MOH file.
filename—Filename of the music file. The
•
music file must reside in flash memory.
Selects the multicast-enabled MOH audio source
in the User Hold MOH Audio Source field on the
Phone Configuration page in Cisco Unified CM
Administration GUI.
Cisco Unified SCCP and SIP SRST System Administrator Guide
299