How to Set Up Cisco Unified IP Phones
Examples
In the following example, octo-line mode is enabled, there are 8 octo-line directory numbers, there are
a maximum of 23 directory numbers, and a maximum of 6 channels are available for incoming calls:
!
call-manager-fallback
max-dn 23 octo-line 8
huntstop channel 6
Configuring the Maximum Number of Calls
To configure the maximum number of calls on a Cisco Unified SCCP IP phone in Cisco Unified SRST
9.0, perform the following steps.
Prerequisites
•
•
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Cisco Unified SCCP and SIP SRST System Administrator Guide
100
Cisco Unified SRST 9.0 and later versions.
Correct firmware, 9.2(1) or a later version, is installed.
enable
configure terminal
call-manager-fallback
max-dn max-no-of-directories [dual-line | octo-line]
timeouts busy seconds
end
Setting Up Cisco Unified IP Phones using SCCP
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enables Cisco Unified SRST support and enters
call-manager-fallback configuration mode.
OL-13143-04