Cisco CP-7911G-CH1 System Administrator Manual page 144

How to Configure Cisco Unified SCCP SRST
DETAILED STEPS
Command or Action
Step 1
show voice translation-rule number
Example:
Router# show voice translation-rule 6
Translation-rule tag: 6
Rule 1:
Match pattern: 65088801..
Replace pattern: 6508880101
Match type: none
Match plan: none
Step 2
test voice translation-rule number input-test-string
[type match-type [plan match-type]]
Example:
Router(config)# voice translation-rule 5
Router(cfg-translation-rule)# rule 1 /201/ /102/
Router(cfg-translation-rule)# end
Router# test voice translation-rule 5 2015550101
Matched with rule 5
Original number:2015550101
number:1025550101
Original number type: none
type: none
Original number plan: none
plan: none
Configuring Dial-Peer and Channel Hunting
Dial-peer hunting, the search through a group of dial peers for an available phone line, is disabled during
Cisco Unified CM fallback by default. To enable dial-peer hunting, use the no huntstop command. For
more information about dial-peer hunting, see
If you have a dual-line phone configuration, see the
Keep incoming calls from hunting to the second channel if the first channel is busy or does not answer
by using the channel keyword in the huntstop command.
Channel huntstop also prevents situations in which a call can ring for 30 seconds on the first channel of
a line with no person available to answer and then ring for another 30 seconds on the second channel
before rolling over to another line.
SUMMARY STEPS
1.
2.
3.
Cisco Unified SCCP and SIP SRST System Administrator Guide
144
Replace type: none
Replace plan: none
Translated
Translated number
Translated number
call-manager-fallback
huntstop [channel]
exit
Purpose
Use this command to verify the translation rules that
you have defined for your translation profiles.
Use this command to test your translation profiles.
See the test voice translation-rule
Cisco IOS Voice Command Reference
information.
Cisco IOS Voice Configuration
"Configuring Dual-Line Phones" section on page
Configuring Call Handling
command in
for more
Library.
96.
OL-13143-04