Where To Go Next - Cisco CP-7911G-CH1 System Administrator Manual

Where to Go Next

DETAILED STEPS
Command or Action
Step 1
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 2
keepalive seconds
Example:
Router(config-cm-fallback)# keepalive 60
Step 3
exit
Example:
Router(config-cm-fallback)# exit
Examples
The following example sets a keepalive interval of 45 seconds:
call-manager-fallback
keepalive 45
Where to Go Next
The next step is setting up the phone and getting a dial tone. For instructions, see the
"Cisco Unified SIP SRST 4.1" section on page
For additional information, see the
SCCP and SIP SRST Feature Overview"
Cisco Unified SCCP and SIP SRST System Administrator Guide
74
Purpose
Enters call-manager-fallback configuration mode.
Sets the time interval, in seconds, between keepalive
messages that are sent to the router by Cisco Unified IP
Phones.
seconds: Range is 10 to 65535. Default is 30.
•
Exits call-manager-fallback configuration mode.
75.
"Additional References" section on page 26
chapter.
Setting Up the Network
in the "Cisco Unified
OL-13143-04