Cisco CP-7911G-CH1 System Administrator Manual page 161

Configuring Call Handling
In the following configuration example, COR lists are created and applied to the dial peer:
dial-peer cor list call911
member 911
dial-peer cor list call1800
member 1800
dial-peer cor list call1900
member 1900
dial-peer cor list calllocal
member local_call
dial-peer cor list engineering
member 911
member local_call
dial-peer cor list manager
member 911
member 1800
member 1900
member local_call
dial-peer cor list hr
member 911
member 1800
member local_call
In the example below, five dial peers are configured for destination numbers 734...., 1800.......,
1900......., 316...., and 911. A COR list is applied to each of the dial peers.
dial-peer voice 1 voip
destination pattern 734....
session target ipv4:10.1.1.1
cor outgoing calllocal
dial-peer voice 2 voip
destination pattern 1800.......
session target ipv4:10.1.1.1
cor outgoing call1800
dial-peer voice 3 pots
destination pattern 1900.......
port 1/0/0
cor outgoing call1900
dial-peer voice 5 pots
destination pattern 316....
port 1/1/0
! No COR is applied.
dial-peer voice 4 pots
destination pattern 911
port 1/0/1
cor outgoing call911
Finally, the COR list is applied to the individual phone numbers.
call-manager-fallback
max-conferences 8
cor incoming engineering 1 1001 - 1001
cor incoming hr 2 1002 - 1002
cor incoming manager 3 1003 - 1008
OL-13143-04
How to Configure Cisco Unified SCCP SRST
Cisco Unified SCCP and SIP SRST System Administrator Guide
161