Cisco CP-7911G-CH1 System Administrator Manual page 153

Configuring Call Handling
You can continue to use the app-h450-transfer.2.0.0.1.tcl script if you install Cisco IOS
Note
Release 12.2(11)YT1 or later, but you cannot use the app-h450-transfer.2.0.0.2.tcl script with a release
of Cisco IOS software that is earlier than Cisco IOS Release 12.2(11)YT1.
Restrictions
•
•
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
OL-13143-04
Tcl IVR 2.0
–
H.450 Tcl script (app-h450-transfer.tcl)
–
When a consultative transfer is made by an analog FXS phone using hookflash, the consultation call
itself cannot be further transferred (that is, it cannot become a recursive or chained transfer) until
after the initial transfer operation is completed and the transferee and transfer-to parties are
connected. After the initial call transfer operation is completed and the transferee and transfer-to
parties are now the only parties in the call, the transfer-to party may further transfer the call.
Call transfer with consultation is not supported for Cisco ATA-186, Cisco ATA-188, and Cisco IP
Conference Station 7935. Transfer attempts from these devices are executed as blind transfers.
call application voice application-name location
call application voice application-name language number language
call application voice application-name set-location language category location
call application voice application-name delay-time seconds
dial-peer voice number pots
application application-name
exit
dial-peer voice number voip
application application-name
exit
How to Configure Cisco Unified SCCP SRST
Cisco Unified SCCP and SIP SRST System Administrator Guide
153