Signal Support; Language Support; Switch Support; Where To Go Next - Cisco CP-7911G-CH1 System Administrator Manual

Cisco Unified SCCP and SIP SRST Feature Overview

Signal Support

Cisco Unified SRST supports FXS, FXO, T1, E1, and E1 R2 signals.

Language Support

See

Switch Support

Cisco SRST 3.2 and later versions support all PRI and BRI switches including the following:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Where to Go Next

The next chapters of this book describe how to configure Cisco Unified SIP SRST. As shown in
each chapter takes you through tasks in the order in which they need to be performed. The first task for
configuring Cisco Unified SRST is to ensure that the basic software and hardware in your system are
configured correctly for Cisco Unified SRST.
Table 3
Task
1.
2.
3.
OL-13143-04
Cisco Unified Communications Manager Express Cisco Unified CME Localization
basic-1tr6
basic-5ess
basic-dms100
basic-net3
basic-ni
basic-ntt NTT switch type for Japan
basic-ts013
primary-4ess Lucent 4ESS switch type for the United States
primary-5ess Lucent 5ESS switch type for the United States
primary-dms100 Northern Telecom DMS-100 switch type for the United States
primary-net5 NET5 switch type for the United Kingdom, Europe, Asia, and Australia
primary-ni National ISDN switch type for the United States
primary-ntt NTT switch type for Japan
primary-qsig QSIG switch type
primary-ts014 TS014 switch type for Australia (obsolete)
Cisco Unified SRST Configuration Sequence
Setting up a Cisco Unified SRST system
to communicate with your network
Configuring Version 4.1 features
Setting up the basic Cisco Unified SRST
phone configuration using SCCP
Where Task Is Described
Setting Up the Network, page 63
Cisco Unified SIP SRST 4.1, page 75
Setting Up Cisco Unified IP Phones using SCCP,
page 85
Cisco Unified SCCP and SIP SRST System Administrator Guide
Where to Go Next
Matrix.
Table 3,
25